I have been at the stoplight heading north on S. Walnut St. at the Rhorer Rd intersection twice lately and the stoplight does not register that you are waiting on the light to change. There must be something wrong with the sensor at this light. Thanks!
Traffic light works, but then stops & starts flashing yellow going east & west. Landmark turning East or west gets flashing red.
When cars turn off of 10th st onto sunrise or in to the parking lot at teter quad, the light turns red for 10th st needlessly.
The crosswalk signal never changes to WALK. I stood on the NE corner of Kirkwood and Adams, trying to cross Kirkwood to go south toward Rose Hill. I pushed the button and watched through several cycles (for more than three minutes) and it never changed. It was the same way last Sunday, too.
Pedestrian sign outside Samira (northwest corner of 6th/Walnut) doesn't have functioning white bulbs, or, it is only displaying the countdown and "do not walk" signals and never the white walk signal. Thanks!
A tree branch is obscuring the yellow turn arrow on a traffic signal at 2nd and High. The traffic signal is for westbound traffic on 2nd Street. The signal itself is located on the western side of the intersection and is the southern (left when looking at the lights as traffic would) signal hanging there. It should be trimmed up.
Cross walk signals for those walking never changes from red "stop - don't walk" light, even after pushing the button requesting a cross.
Walnut southbound left turn arrow onto Grimes east cycles green every time and there's rarely a car turning left. Plus the northbound left turn arrow for Grimes/Patterson doesn't stay green long enough causing traffic to back up almost to Hillside at times.
Left turn arrow on northbound Walnut at Hillside is cycling green for 30 seconds everytime, with no cars on the loop.