closed #189045
Traffic Signals
2498 S Walnut St, Bloomington, IN 47401, USA
- Case Date:
- 6/20/2024
The left turn arrow from northbound Walnut to westbound Country Club is not giving the green arrow.
The left turn arrow from northbound Walnut to westbound Country Club is not giving the green arrow.
Turn signal and always come on even when no cars are present
The traffic light at the intersection of 3rd St. and Hillsdale is currently on a timed cycle that doesn't seem to change at any point during the day. It would be better if there were sensors or something, because I find myself stopping and waiting the entire light cycle sometimes, with no sign of anyone coming from the other street, and that's a waste of time and fuel. So if that ought could give more default preference to the traffic on 3rd St., that would be awesome.
To whom it may concern: I'm writing today about the intersection of S. Hillsdale Dr and E 3rd St in Bloomington, Indiana. Specifically, I'm concerned with the functioning of the traffic signal at that intersection. In short, because the stop line is set pretty far back on Westbound lane of E 3rd St, Westbound drivers rushing through the yellow light have to go a very long way, much longer than those of us using the yellow to make a left turn northbound onto Hillsdale (when there is traffic, there is no choice except making left on the yellow). I'm not doing a great job explaining it here but given the long set-back, it seems odd that both of those lights turn yellow at the same time. I'd be happy to explain better via phone and/or someone could easily observe this dynamic at said intersection. Thanks
All of the traffic signals on the intersection of W 3rd Street and South Madison Street AS WELL AS W 3rd Street and South Rogers Street are NOT ON. It is as if they do not have any power.
3rd and Madison, northwest corner, the Wait/Don't Wait signal is covered. I believe this was reported many months ago, but can't find it in the system. Not sure why it would take this long to get repaired. But if it's a part, shouldn't that be followed up on? Thanks.
At the corner of Rogers St and Graham Dr a push button for yellow blinking lights does not work. It is on the south-west corner of the intersection.
The traffic signal at Bryan St at the intersection with 3rd and High Streets is not working properly. It does not cycle to green in sequence with the other streets unless the front car pulls forward into the crosswalk. This creates an unsafe situation for both pedestrians and drivers. Please fix the light so that it cycles properly with the signals for the other streets. Thank you.
On several occasions I've pulled up to the left turn lane stop line going south on Henderson at Winslow and have not gotten a green light. I arrived at the intersection just as Henderson northbound is getting a green light and green turn arrow, and there are no cars yet at the red lights on Winslow. Once the northbound left turn traffic is done, the southbound light never goes green. So I sit and wait for an entire cycle before getting a green arrow three minutes later.
I've reported intermittent malfunctions at this light before. This time I was heading north bound on Henderson and stopped in the center lane at the red light for Winslow. The light was green both directions on Winslow at the time. The light then went red on Winslow and turned green with a green arrow for the south bound cars stopped on Henderson. After these cars went through, the traffic light went green again for Winslow and I never received a green light. The second time around, a car came alongside me in the left lane and I then got a green light after sitting for two plus minutes a second time around. The light is also set to green too long for Winslow.