Case Date:

7/3/2015

I often bike north on Jordan avenue to 3rd St., then turn left onto 3rd with the traffic light. Before the recent construction, the left turn signal appeared to be on a timer, and now it seems to be activated by a metal-sensitive loop in the pavement. But so far I have been unable to trigger the left turn signal with my bicycle. I have been instructed to ride exactly on the wire, and I ride a steel frame bike from 1970, so it should have plenty of metal to be detected. Is there some way to make sure this traffic light actuator is sensitive enough to work for bicyclists as well as for cars?

Case Date:

8/25/2015

Traffic signal is not working since the last 4 days

Case Date:

7/18/2018

Stoplight may show green to both east bound and south bound at the same time. Unless cars are running solid red lights.

Case Date:

3/25/2022

Please check timing if this light. Only 5 cars can get through the left turn light when turning east from the north.

Case Date:

11/9/2023

The turn light on eastbound 3rd street going onto N. Gates Dr. stays on even when there are no cars turning.

Case Date:

7/17/2024

Pedestrian signal missing on the ne corner of Eagleson and Atwater crossing Eagleson

Case Date:

7/17/2024

Pedestrian signal missing on the ne corner of Eagleson and Atwater crossing Eagleson

Case Date:

11/5/2014

The crew putting down straw bales appears to have knocked over the stop sign at Yonkers.

Case Date:

12/30/2017

Stop sign ran over and is no longer up.

Case Date:

12/1/2020

The vehicle sensors on Clarizz don't seem to be detecting correctly. I have set at that intersection, and the traffic signals take a long time to change, even if there's no traffic on 3rd Street. Wasn't sure if that is the way it is supposed to be or not.